So now that I am back out my house with access to all my motors, the raspberry pi and wood I was able to carry out a couple of measurings onto the wood. I decided to use yesterdays sketches as a rough guide as you where to place the motors but actually using the motors and board to get the correct dimensions. Tomorrow and over the week I probably will only be able to slowly draw out all of the pieces without cutting them, that will probably have to wait untill the weekend.

Tbh I think this was possibly a bad project for lent, the sketching one is great becuase it doesn't need to take long but I can do it anywhere at anytime. It's also a skill with no set restrictions or goals I just sketch a pose I think is interesting or will stretch my ability a bit more each time. This requires more methodical approach while not necessarily always chipping away. But it has kept the project at the forefront of my mind so I guess that's a benefit. After this weekend it will be easier to work on it becuase all the chasis will be ready I just need to program it. Then I can try cool things but that's a week away. Any anypony reading this, which I doubt, sorry for the boring tediousness of the project so far.